標(biāo)題: Servo+Knob Arduino代碼 [打印本頁]
作者: EdwardGU123    時間: 2023-1-1 18:02
標(biāo)題: Servo+Knob Arduino代碼
  1. /*
  2. Controlling a servo position using a potentiometer (variable resistor)

  4. modified on 8 Nov 2013
  5. */

  7. #include <Servo.h>

  9. Servo myservo;  // create servo object to control a servo

  11. int potpin = 0;  // analog pin used to connect the potentiometer
  12. int val;    // variable to read the value from the analog pin

  14. void setup() {
  15.   myservo.attach(9);  // attaches the servo on pin 9 to the servo object
  16. }

  18. void loop() {
  19.   val = analogRead(potpin);            // reads the value of the potentiometer (value between 0 and 1023)
  20.   val = map(val, 0, 1023, 0, 180);     // scale it to use it with the servo (value between 0 and 180)
  21.   myservo.write(val);                  // sets the servo position according to the scaled value
  22.   delay(15);                           // waits for the servo to get there
  23. }


復(fù)制代碼






歡迎光臨 (http://www.torrancerestoration.com/bbs/) Powered by Discuz! X3.1